 |
||||||||||||
| Honda F4I Ignition Unit (2001 onwards) - Modification Ref: 040816P1 | |||||||||||
|
Advantages are a peak power increase, the ability to over rev
the machine and hold the gear longer before up-shifting, which particularly benefits short circuit courses. This modification shows no significant loss of power in the low or midranges as per dyno graph above on a 2001unit modified +10% used for racing. The HONDA CBR 600 F4i unit standard limiting starts at 14000 rpm approx, with the above service extending this limit to 15500rpm APPROX. before limiting occurs. |
|||||||||||
| ||||||||||||
| ||||||||||||
| ||||||||||||
| ||||||||||||
| ||||||||||||
|
|
Dyno Graph Of Unit Before/After Modification Dyno graph courtesy of Clifford Cycles (Nebraska USA) |
|||||||||||
 |
||||||||||||
| F A Q's for Honda F4I Ignition Unit ECU Service: | ||||||||||||
| Q: | Will the service give more BHP? | |||||||||||
| A: | As the above graph shows, there is some power increase BUT the RPM can be held longer to save on gear changes. Power will only really come with proper Fuel/Air adjustments. | |||||||||||
| Q: | How much is the F/A altered by on this service? | |||||||||||
| A: | The F/A graph will be shifted by approx 10% from standard, meaning that for example when the engine is running at 10000RPM it will be fuelling for 9100 RPM approx. In most of the ECU's that we have done for this engine the F/A has never had to be changed by rejetting, except sometime for engines running ALCOHOL (Methanol) where extreme tuning has taken place. If in doubt, get your F/A checked by your tuner. | |||||||||||
| Q: | Will the Tachometer still read as before or has the service changed this? | |||||||||||
| A: | No issues with tachometer readings etc on the standard Honda gauge. | |||||||||||
| Q: | Will an aftermarket alarm system or immobilizer still work with this modified ECU? | |||||||||||
| A: | Yes absolutely no changes have been made to the electrical operation of the ECU. | |||||||||||
| Q: | My bike is fitted with a NON STANDARD exhaust system/can, will this service still work as shown? | |||||||||||
| A: | The ECU will still operate as described above, but as mentioned, if you are in ANY doubt, then please get your Tuner to check your F/A ratio to be sure that all is correct | |||||||||||
| Q: | I have a USA ECU, any problems doing this service? | |||||||||||
| A: | No issues as the HISs system is not altered with this model of ECU | |||||||||||
|
WARNING!, After having this ECU service it is strongly advised that your tuner check your FUEL/AIR ratios
throughout the RPM range as changes may be required after this service. **(see FAQ section on the F3 ECU) |
||||||||||||
| This service does NOT guarantee to increase power as it is used primarily on modified engines and to extend the RPM range for racing purposes. | ||||||||||||
| WARNING: These modifications are advised with caution due to stresses caused by the additional RPM available to the rider and are only suitable for a race prepared engine, which can handle the additional RPM available. | ||||||||||||
| Please consult your Tuner or Garage if ANY in doubt. | ||||||||||||
