Logo

Yamaha R6 (2003 - 2005) ECU Modification. - mod 040403 P1

Advantages are a peak power increase, the ability to over rev the machine and hold the gear longer before up-shifting, which particularly benefits short circuit courses. This modification shows no significant loss of power in the low or midranges as per dyno graph below on a 2004 unit modified +11% used for racing.

The R6 injected unit standard limiting starts at 14900rpm, with the above service extending this limit to 16100rpm APPROX. before limiting occurs.

NOTE: THIS SERVICE IS FOR USA ECU's ONLY!! UK ECU's have antitheft fitted and as such can only be modified approx 3% from standard.

**PLEASE NOTE** at the time of ordering you will need to specify if you would like a 5% or 10% overclocked unit

GSXR600

     
  Terms & Conditions ~ Please Read  
Spec Graph Spec Graph
FAQ's for Yamaha R6 (2003 - 2005) ECU Service:
Q:
Will the service give more BHP?
A: There is no real power increase, BUT the RPM is higher and therefore each gear can be held longer to save on gear changes.
Q:
How much is the F/A altered on this service?
A: The F/A mix will be shifted by approx 11% from standard, meaning that for example when the engine is running at 10000RPM it will be fuelling for 9100RPM. In most of the ECU's that we have completed the F/A has not had to be changed by re-jetting. However, sometimes engines running ALCOHOL (Methanol) have required recalibration where extreme tuning has taken place. If in doubt, get your F/A checked by your tuner.
Q:
Will an aftermarket alarm system or immobilizer still work with this modified ECU?
A: Yes absolutely no changes have been made to the electrical operation of the ECU.
Q:
Will the Tachometer still read as before or has the service changed this?
A: No issues with the modification on the Tachometer accuracy/function EXCEPT that the diagnostics function will NOT work due to the overclocking of the ECU.  Please email:sales@vtac.co.uk for more information on this.
Q:
My bike is fitted with a NON STANDARD exhaust system/can, will this service still work as shown?
A: The ECU will still operate as described above, but as mentioned, if you are in ANY doubt, then please get your tuner to check your F/A ratio to be sure that all is correct.

WARNING!, After having this ECU service it is strongly advised that your tuner check your FUEL/AIR ratios throughout the RPM range as changes may be required after this service.

This kind of service does NOT guarantee to increase power as it is used primarily on modified engines and to extend the RPM range for racing purposes.

WARNING: These modifications are advised with caution due to stresses caused by the additional RPM available to the rider and are only suitable for a race prepared engine, which can handle the additional RPM available. Please consult your Tuner or Garage if ANY in doubt.

Terms & Conditions ~ Privacy Statement